Hi y’all!  It’s Susan Lee Rose from @susanleeroseblog here again to show you a really quick card using the All About Him Stamp Set.  I was able to whip up this simple but elegant card in no time flat!

 

Materials:

—BM Lunchbag, Jurassic and Black Cardstock https://bit.ly/3pxcoZU

— Memento Dew Drop- Northern Pine Dye Ink  https://bit.ly/3h9gDa6

–All About Him Stamp Set https://bit.ly/3dmfMlw

–VersaMark Ink https://bit.ly/3dn6ZPX

—Nuvo Gold Embossing Powder https://bit.ly/3ju7xr4

—WRMK Scallop/Stub Crop-A-Dile https://bit.ly/3gmmuZn

–MISTI https://bit.ly/3y7oyM9

—Tonic Teflon Bone Folder  https://bit.ly/3vroXsa

—WRMK Score Board  https://bit.ly/3xKsrX6

—Tonic Paper Trimmer  https://bit.ly/3w8x6B2

—Marvy Heat Embossing Tool  https://bit.ly/3djpNQ3

—Bearly Art Glue  https://bit.ly/3rUZHs4

—Cutter Bee Scissors https://bit.ly/3v0jgjB

–3D Foam Squares https://bit.ly/3cxTpYP

—EK Success Powder Applicator Tool https://bit.ly/35Wou5w

 

Cut Directions:

Lunchbag Cardstock

–4-1/4” x 11”, score at 5-1/2” (Card Base)

Jurassic Cardstock

–3” x  5-1/2”

–4-1/4” x  5-1/2”

–2” x 2”

Black Cardstock

–5-1/2” x 2”

–2-1/2” x 2-1/2”

 

Directions:

1. Cut out all the paper according to the cut directions.

2. Stamp the Herringbone image from the All About Him Stamp Set onto the 3” x 5-1/2” cardstock using the Northern Pine Ink.  Trim to the edge of the Herringbone pattern.

3. Mount the Herringbone strip on top of the 5-1/2” x 2” piece of black cardstock with 3D Foam Squares

4. Using the Bearly Art Glue, mount the Herringbone strip to the bottom of the 4-1/4” x 5-1/2” piece of dark green cardstock, about ¼” from the bottom.

5. Mount the 4-1/4” x 5-1/2” piece of dark green cardstock to the top of the lunchbag card base using the Bearly Art Glue.

6. Stamp the sentiment onto the 2” x 2” piece of dark green cardstock using the VersaMark ink.

7. Sprinkle the gold embossing powder over the VersaMark inked sentiment.  Gently shake off excess and heat emboss with a heat embossing tool.

8. Use the Scallop/Stub Crop-A-Dile to scallop the corners of the 2” x 2” sentiment block and the 2-1/2” x 2-1/2” piece of black cardstock.  Glue the dark green sentiment block to the black cardstock.

9. Mount the sentiment block to the front of the card using the 3D Foam Squares.